RSX L4-2.0L (2005)
8. Insert a 6.0 mm (0.24 inch) pin (A) through the positioning hole (B) on the shift lever bracket base and into the positioning hole (C) on the shift
lever. The shift lever is secured in the N position.
9. Align the socket holder (A) on the shift cable (B) with the slot in the bracket base (C), then slide the holder into the base. Install the shift cable end
(D) over the mounting stud (E) by aligning its square hole (F) with the square fitting (G) at the bottom of the stud. Rotate the holder a quarter turn
to secure the shift cable. Do not install the shift cable by twisting the shift cable guide (H).
10. Verify that the shift cable end (A) is properly installed, on the mounting stud (B).
11. If improperly installed, remove the shift cable from the shift lever bracket base, and reinstall the shift cable. Do not install the shift cable end on
the mounting stud while the shift cable is on the shift lever bracket base.