RSX L4-2.0L (2005)
Axle Shaft Assembly: Service and Repair
Driveshaft Disassembly
Driveshaft Disassembly
Special Tools Required
-
Threaded adapter, 22 x 1.5 mm 07XAC-001010A
-
Threaded adapter, 24 x 1.5 mm 07XAC-001020A
-
Boot band pincers, Kent-Moore J-35910 or equivalent, commercially available
-
Slide hammer, 5/8" x 18 UNF, commercially available
Inboard Joint Side
1. Remove the set ring from the inboard joint.
2. Remove the boot bands. Be careful not to damage the boot and dynamic damper.
-
If the boot band is a welded type (A), cut the boot band (B).
-
If the boot band is a double loop type (C), lift up the band end (D), and push it into the clip (E).
-
If the boot band is a low profile type (F), pinch the boot band using commercially available boot band pincers (G).
Welded Type
Double Loop Type
