RSX L4-2.0L (2005)
13. Apply primer to the inside face of the rear window (A), and attach the molding (B):
-
With the printed dots (C) on the upper and side portions of the rear window as a guide, attach the molding around the edge of the rear window.
-
Before installing the molding, fold the edge of the adhesive backing on the double-sided adhesive tape. After installing the molding, pull the
adhesive backing away, then attach the molding into place.
-
Be careful not to touch the rear window where adhesive will be applied.
14. Attach the upper seal (A) with adhesive tape (B) onto the upper portion of the molding (C):
-
Be sure the alignment mark (D) of the seal lines up with the alignment mark (E) of the windshield.
-
Be careful not to touch the window where adhesive will be applied.