RSX L4-2.0L (2005)
18. With a sponge, apply a light coat of glass primer along the edge of the upper molding (A) and rear window molding (B) as shown, then lightly
wipe it off with gauze or cheesecloth:
-
With the printed dots (C) on the rear window (D) as a guide, apply the glass primer to both side portions of the rear window.
-
Do not apply body primer to the rear window, and do not get the hatch and glass primer sponges mixed up.
-
Never touch the primed surfaces with your hands. If you do, the adhesive may not bond to the rear window properly, causing a leak after the
rear window is installed.
-
Keep water, dust, and abrasive materials away from the primed surfaces.
19. With a sponge, carefully apply a light coat of body primer to any exposed paint around the flange-where new adhesive will be applied. Let the
primer dry for at least 10 minutes:
-
Do NOT apply body primer to any remaining original adhesive on the flange.
-
Be careful not to mix up the body and glass primer sponges.