RSX L4-2.0L (2005)
3.
Test-drive the vehicle.
^
If the noise is gone, remove the masking tape, then go to REPAIR PROCEDURE.
^
If the noise is still there, disregard this bulletin, and look for other possible causes.
REPAIR PROCEDURE
1.
Protect the paint by applying a 2-inch-wide strip of masking tape along the edge of the molding at the roof and the A-pillars.
2.
Pull up the outer edge of the molding with an 0-ring pick, then fill the entire channel length under the molding with 3M Black Super Silicone
Sealant.
3.
Push down on the molding, and smooth it out until it sits flush with the roof.
4.
Wait 5 minutes, then remove the masking tape.
5.
Clean off any excess sealant with 3M General Purpose Adhesive Cleaner.
Disclaimer
