RSX L4-2.0L (2005)
Windshield: Service and Repair
Windshield Replacement
Special Tools Required
KTC trim tool set SOJATP2014
NOTE:
-
Put on gloves to protect your hands.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when pitying components.
-
Wear eye protection when removing the glass with piano wire.
-
Use seat covers to avoid damaging the seats.
1. Pull up the side trim (A) to release the clips (B, C) from the retainers (D), then remove the trim from each side of the windshield.
2. Remove these items:
-
Windshield wiper arms
-
Cowl covers
3. Remove the molding (A) from the upper edge of the windshield (B). If necessary, cut the molding with a utility knife.
4. If the old windshield will be reinstalled, make alignment marks across the glass and body with a grease pencil.
5. Pull down the front portion of the headliner. Take care not to bend the headliner excessively, as you may crease or break it.
6. Apply protective tape along the edge of the dashboard and body. Using an awl, make a hole through the rubber dam and adhesive from inside the
vehicle at the corner portion of the windshield. Push a piece of piano wire through the hole, and wrap each end around a piece of wood.
