SLX V6-3.2L SOHC (1996)
^
The vacuum lines must be properly routed under the throttle body before tightening the mounting bolts.
Tighten:
Tighten the throttle body mounting bolts to 13.47 N.m (120 lb in.).
6. Install the coolant lines.
7. Connect all the vacuum lines.
8. Install the intake air duct.
9. Tighten the intake air duct clamp.
10. Connect all the electrical connectors:
^
Throttle position (TP) sensor.
^
Idle air control (IAC) solenoid.
^
Linear EGR valve (EGR). Refer to Linear EGR Valve.
^
Intake air temperature (IAT) sensor. Refer to Intake Air Temperature Sensor.
11. Install the accelerator cable assembly. Refer to Accelerator Cable Assembly
12. Fill the cooling system. Refer to Cooling System.
13. Install the negative battery cable.
