SLX V6-3.2L SOHC (1996)
Differential Case: Service and Repair
1. On models less limited slip differential, install side gears and thrust washers in differential case.
Fig. 22 Positioning pinion gears
2. Position pinion gears 180° apart, Fig. 16, then roll gears into position, making sure they are aligned, to allow installation of pinion shaft.
3. Place thrust block between pinion gears and drive pinion into place. Make sure the lockpin hole in the cross shaft lock aligns with hole in case.
4. Check backlash between differential gears and pinion gears. If backlash is greater than .003 inch, make necessary adjustments with thrust washers.
Thrust washers are available in thicknesses of .041, .045, .049 and .053 inch. Increasing washer thickness will decrease backlash.
Decreasing washer thickness will increase backlash.
Fig. 23 Installing lockpin
5. Install cross shaft lockpin, Fig. 17, then caulk end to avoid loosening.
