SLX V6-3.2L SOHC (1996)
Fig. 18 Dimensions A, B, & C Measurement
6. On models with limited slip differential, to set differential housing to carrier housing clearance, measure dimensions A, B and C, Fig. 18, then
place pinion cross shaft in pressure rings, install friction plates and discs on pressure rings and measure dimension D Fig. 19.
7. Measure thickness of a spring disc and multiply by 4, this will equal dimension E. Using formula (A - B) + C - (D + E) = X, select friction discs or
plates to adjust dimension D to give a result of 0.002 to 0.008 inch for X. Variance in thickness of friction discs or plates should not exceed 0.020
inch.
