SLX V6-3.2L SOHC (1996)
2.
Using an 0-ring pick or similar tool, pull the rubber molding away from the A-pillar. Apply 3M Super Silicone Sealant (see REQUIRED
MATERIALS) under the rubber molding along the full length of the A-pillar.
3.
Press the rubber molding against the A-pillar with your fingers to smooth it out and make sure it sits flush.
4.
Allow the sealant to set for about 5 minutes. Remove the masking tape and clean up any excess adhesive with 3M General Purpose Adhesive
Cleaner.
5.
Repeat steps 1 thru 4 on the other A-pillar.
WARRANTY CLAIM INFORMATION
In warranty:
The normal warranty applies.
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Technical Manager or your Zone Office. You
must request consideration, and get a decision, before starting work.
Operation number:
824701
Flat rate time:
0.4 hour
Failed P/N:
8-94358-797-6
Defect code:
056
Contention code:
B07