TL L5-2451cc 2.5L SOHC G25A4 FI (1995)
Air Bag: Service and Repair
After a collision in which the airbags were deployed, the airbag assemblies and the SRS unit must be replaced.
WARNING: Store a removed airbag assembly with the pad surface up. If the airbag is improperly stored face down, accidental deployment
could propel the unit with enough force to cause serious injury.
CAUTION:
^
Always disconnect the airbag connectors when the SRS main harness is disconnected.
^
'95-96 Model: Always keep the short connector (RED) on the passenger's airbag when the harness is disconnected.
^
Do not disassemble or tamper with the airbag.
NOTE:
^
Do not install used SRS parts from another vehicle. When repairing, use only new SRS parts.
^
Carefully inspect the airbag before you install it. Do not install an airbag that shows signs of being dropped or improperly handled, such as dents,
cracks or deformation.
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
3. Disconnect the airbag connectors:
Driver's Side
Driver's Side:
^
Remove the access panel from the steering wheel, then disconnect the 2P connector between the driver's airbag and cable reel.
Front Passenger's Side
Front Passenger's Side:
^
Remove the glove box, then remove the short connector (RED) from it's holder.
^
Disconnect the 3P connector between the front passenger's airbag and SRS main harness, then connect the short connector (RED) to the airbag
