TL L5-2451cc 2.5L SOHC G25A4 FI (1995)
Clockspring Assembly / Spiral Cable: Service and Repair
WARNING: Store a removed airbag with the pad surface up. If the airbag is improperly stored face down, accidental deployment could propel
the unit with enough force to cause serious injury.
CAUTION:
^
Always disconnect the airbag connector when the SRS main harness is disconnected.
^
Do not disassemble or tamper with the airbag.
NOTE: Carefully inspect the airbag before installing it. Do not install an airbag that shows signs of being dropped or improperly handled, such as dents,
cracks or deformation.
1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the radio's preset buttons.
2. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
Driver's Airbag
3. Remove the access panel from the steering wheel, then disconnect the 2P connector between the driver's airbag and cable reel.
4. Make sure the wheels are aligned straight ahead.
5. Remove the dashboard lower cover.
Driver's Airbag
6. Remove the driver's airbag assembly from the steering wheel (two T3O Torx bolts).
