TL L5-2451cc 2.5L SOHC G25A4 FI (1995)
Fig. 24 Righthand Side Dash Sensor Installation
2. To remove righthand side dash sensor, proceed as follows:
a. Remove door sill molding, then pull carpeting back.
b. Remove Electronic Control Module (ECM), Fig. 24.
c. Remove sensor cover attaching screws, then remove cover.
d. Disconnect electrical connector, then remove two dash sensor attaching bolts and dash sensor.
INSTALLATION
1. Ensure battery cables are disconnected and red short connector is connected to air bag electrical connector.
2. To install lefthand side dash sensor, proceed as follows:
a. Install dash sensor and two attaching bolts, Fig. 23. Tighten attaching bolts to specifications.
b. Connect dash sensor electrical connector.
c. Install sensor cover and two attaching screws.
d. Position carpeting back, then install door sill molding and foot rest.
3. To install righthand side dash sensor, proceed as follows:
a. Install dash sensor and two attaching bolts, Fig. 24. Tighten attaching bolts to specifications.
b. Connect dash sensor electrical connector.
c. Install sensor cover and two attaching screws.
d. Install Electronic Control Module (ECM).
e. Position carpeting and install door sill molding.