TL L5-2451cc 2.5L SOHC MFI (1997)
Brake Pad: Testing and Inspection
Rear
WARNING:
-
Never use an air hose or dry brush to clean brake assemblies.
-
Use an OSHA-approved vacuum cleaner to avoid breathing brake dust.
1. Block the front wheels, loosen the rear wheel nuts slightly, support the rear of vehicle on safety stands, then remove the rear wheels.
2. Release the parking brake.
3. Remove the two caliper bolts and the caliper from the bracket.
CAUTION:
-
Thoroughly clean the outside of the caliper to prevent dust and dirt from entering inside.
-
Support the caliper with a piece of wire so that it does not hang from the brake hose.
4. Remove the Dad shims and brake pads.
5. Using vernier calipers, measure the thickness of each brake pad lining.
Brake Pad Thickness:
Standard: 8.5 - 9.5 mm (0.33 - 0.37 inch)
Service Limit: 1.6 mm (0.06 inch)
NOTE: Measurement does not include pad backing plate thickness.