TL L5-2451cc 2.5L SOHC MFI (1997)
6. Remove the pad retainers.
7. Clean the caliper thoroughly; remove any rust, and check for grooves and cracks.
8. Check the brake disc for damage and cracks.
9. Make sure that the pad retainers are installed in the correct positions.
10. Apply Molykote M77 grease to the pad side of the shims. Wipe excess grease off the shims.
11. Install the brake pads and pad shims on the caliper bracket.
WARNING:
-
When reusing the pads, always reinstall the brake pads in their original positions to prevent loss of braking efficiency.
-
Contaminated brake discs or pads reduce stopping ability. Keep grease off the discs and pads.
NOTE: Install the inner pad with its wear indicator facing downward.
12. Rotate the caliper piston clockwise into place in the cylinder, then align the cutout in the piston with the tab on the inner pad by turning the piston
back.
CAUTION: Lubricate the boot with rubber grease to avoid twisting the piston boot. If the piston boot is twisted, back out so it sits properly.
13. Install the brake caliper.
14. Install and tighten the caliper bolts.
15. After installation, check for leaks at hose and line joints and connections, and retighten if necessary.
16. Depress the brake pedal several times to make sure the brakes work, then test-drive.
NOTE: Engagement of the brake may require a greater pedal stroke immediately after the brake pads have been replaced as a set. Several