TL L5-2451cc 2.5L SOHC MFI (1997)
12. Install the circlip in the groove, then remove the special tool.
NOTE: Check that the circlip is seated in the groove properly.
13. Coat a new piston seal with recommended silicone grease in the caliper seal set, and install it in the caliper.
14. Apply recommended rubber grease in the caliper seal set to the sealing lips and inside of a new piston boot, and install it in the caliper.
15. Coat the outside of the piston with brake fluid, and install it on the adjusting bolt while rotating it clockwise with the tool.
CAUTION: Avoid damaging the piston and piston boot.
