TL L5-2451cc 2.5L SOHC MFI (1997)
19. Insert a 24" long, 3/8" drive extension and the special tool into the cylinder from the gearbox side.
CAUTION: Be careful not to damage the inside surface of the housing with the tools.
20. Set the steering gearbox in a press, then press out the cylinder end seal and backup ring from the gearbox.
CAUTION:
-
Keep the tool straight to avoid damaging the cylinder wall. Check the tool angle, and correct it if necessary, when removing the cylinder end
seal.
-
Use a press to remove the cylinder end seal. Do not try to remove the seal by striking the tool. It will break the backup ring, and the cylinder
end seal will remain in the gearbox.
21. Check the rubber stop for damage or deterioration if OK, go on step 22; if not, replace the rubber stop, step as shown. Remove the rubber stop by
prying it out of the gearbox housing with a flat tip screwdriver.
CAUTION: Protect the pry point on the gearbox housing with shop towel.
