TL L5-2451cc 2.5L SOHC MFI (1997)
-
Install the circlip with its radiused side facing out.
21. Apply power steering fluid to the surface of the special tool. Set the new seal rings over the special tool from the smaller diameter end of the
tool, and expand the seal rings.
NOTE:
-
Do not over-expand the seal ring. Install the resin seal rings with care so as not to damage them. After installation, be sure to contract the
seal rings using the special tool (sizing tool).
-
There are two types of sleeve seal rings: black and brown. Do not mix the different types of sleeve seal rings as they are not compatible.
22. Set the special tool in the grooves in the sleeve, and set each ring in each groove securely.
NOTE: After installation, compress the seal rings with your fingers temporarily.
23. Apply power steering fluid to the seal rings on the sleeve, and to the entire inside surface of the special tool.
24. Insert the sleeve into the special tool slowly.
25. Move the sleeve each direction several times to make the seal rings snugly fit in the sleeve.
NOTE: Be sure that the seal rings are not turned up.
26. Apply vinyl tape to the pinion shaft, then coat the vinyl tape with power steering fluid.
