TL L5-2451cc 2.5L SOHC MFI (1997)
63. Install the spring, rack guide screw and locknut on the gearbox housing.
64. Adjust the rack guide screw.
NOTE: After adjusting, check that the rack moves smoothly by sliding the rack right and left.
65. Install the new lock washer in the groove in the steering rack.
66. Screw each rack end into the rack.
67. Hold the steering rack with a wrench and tighten the rack end with another.
CAUTION: Be careful not to damage the rack surface with the a wrench.
68. After tightening the rack end. Stake the four section of lock washer with the tool and hydraulic press.
NOTE:
-
Place the wood block on the press table, then set the lock washer section of the rack end on the wood block securely.
-
Be sure the tool is aligned with the flat sections of the steering rack end before pressing.
-
Stake the lock washer in the center of the flat section of the steering rack end.
