TL V6-3.2L (2004)
12.
Remove the three fasteners from the moonroof pan.
13.
Using isopropyl alcohol and a shop towel, remove any remaining adhesive residue from the moonroof pan.
14.
Open a packet of the adhesion promoter (primer), included in the kit, and apply it to the fastener locations on the moonroof pan. Allow the primer
to dry for 5 minutes.
15.
Peel off the backing on the new fasteners, then apply them in the same positions as the original fasteners.
NOTE:
^
The fasteners are directional, and must be installed as shown. Apply about 10 to 15 lbs of hand pressure on the entire piece.
^
Allow the adhesive and primer to dry for 2 hours before reinstalling the headliner.
16.
Check the dual lock fasteners on the headliner. If the teeth on any of the fasteners are damaged, replace the fasteners, as shown.
17.
Push the headliner into position, and use your middle finger and thumb to squeeze the headliner to the moonroof pan to attach the fasteners.
NOTE:
Do not hit the headliner with your fist. Doing so may cause damage to the moonroof pan.
18.
Reinstall all removed parts in the reverse order of removal.
Disclaimer
