TL V6-3.2L (2004)
Headliner: Service and Repair
Headliner Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
SRS components are located in this area. Review the SRS component locations and the precautions and procedures before performing repairs or service.
NOTE:
-
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
-
Take care not to bend and scratch the headliner.
-
Be careful not to damage the dashboard and other interior trim.
1. Remove these items:
-
A-pillar trim, both sides
-
B-pillar upper trim, both sides
-
C-pillar trim, both sides
-
Rear seat-back
-
Rear map light
-
Vanity light, both sides
2. From both sides, using a trim tool, release the tabs (A), then remove the sunvisor cap (B) from the bracket (C). Turn the cap, and remove it.
3. From both sides, remove the sunvisor (A) and holder (B).
1. Remove the self-tapping ET screws.
2. Remove the sunvisor from the body and holder.
3. Disconnect the vanity mirror light connector (C).
4. Using a flat-tip screwdriver, push the hook (D), turn the holder 90, then pull it out.
4. Remove the moonroof switch.