TL V6-3.2L (2004)
13. Install the cover in the reverse order of removal, and note these items:
-
Reinitialize the OPDS unit.
-
To prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the clips, hooks,
and hook strips.
-
Replace any clips you removed with new ones (A). Install them with commercially available upholstery ring pliers (B).
-
Reinstall the front hook (C) and rear hook (D) of the reinforcing cloth (E) securely.
-
Use only original Honda replacement seat-back covers.
-
Make sure the power seat subharness, side airbag harness, seat-back heater harness, and OPDS unit harness (passenger's seat) are routed
properly.
Seat Cushion Cover
1. Remove the front seat.
2. 10-way power seat: From under the seat cushion, detach the power seat subharness connector clip, the side airbag connector clip and the seat
heater connector clip. Release the seat cushion cover from the seat cushion frame spring, then pull the cover back, and remove the clamps.
3. Remove these items from the front seat:
-
Recline cover
-
Center cover
-
Front cover
4. Remove the seat-back, 4-way power seat, 10-way power seat.
5. Release the hook strips (A) from both sides of the seat cushion.
