TL V6-3.2L (2004)
Brake Caliper: Service and Repair
Removal and Installation
Front Brake Pad Inspection and Replacement
Special Tools Required
-
Brembo brake caliper piston compressor 07AAE-SEPA100
-
Pin driver, 3.5 mm 07744-0010300
CAUTION: Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
-
Avoid breathing dust particles.
-
Never use an air hose or brush to clean brake assemblies. Use an OSHA-approved vacuum cleaner.
Inspection
NOTE: Due to the high performance nature of the brake system on M/T model, the rotors and pads may wear faster than on A/T model. Be sure to
inspect the front rotor thickness anytime the front pads are replaced.
1. Raise the front of the vehicle, and support it with safety stands in the proper locations. Remove the front wheels. Take care not to scratch the
calipers (M/T model).
2. Remove the brake pads.
3. Check the thickness of the brake pads (A). Do not include the thickness of the brake pad backing plate (B).
Brake pad thickness:
Standard:
A/T model: 10.3 - 11.0 mm (0.41 - 0.43 inch)
M/T model (4-piston caliper type):
8.8 - 10.0 mm (0.35 - 0.39 inch)
Service limit: 1.6 mm (0.06 inch)
A/T model
M/T model (4-piston caliper type)
4. If the brake pad thickness is less than the service limit, replace all the brake pads as a set.
Replacement: A/T model
1. Raise the front of the vehicle, and support it with safety stands in the proper locations. Remove the front wheels.