TL V6-3.2L (2004)
5. Remove the pad shims (A) and brake pads (B).
6. Remove the pad retainers (A).
7. Clean the caliper thoroughly; remove any rust and check for grooves and cracks.
8. Check the brake disc/drum for damage and cracks.
9. Install the pad retainers.
10. Apply Molykote M77 grease (P/N 08798-9010) to the pad side of the shims (A), and back of the brake pads (B) and the other areas indicated by
the arrows. Wipe excess grease off the pad shims and brake pads. Contaminated brake discs or pads reduce stopping ability. Keep grease off the
discs and pads.
11. Install the brake pads (B) and pad shims on the caliper bracket. Install the inner brake pad with its wear indicator (C) facing downward. If you are
reusing the brake pads, always reinstall the brake pads in their original positions to prevent a momentary loss of braking efficiency.
12. Push in the piston so the caliper will fit over the brake pads. Make sure the piston boot is in position to prevent damaging it when installing the
caliper.
