TL V6-3.2L (2004)
Brake Rotor/Disc: Specifications
FRONT
Set up the dial gauge against the brake disc as shown, and measure the runout at 10 mm (3/8 inch) from the outer edge of the brake disc.
Brake disc runout
Service limit .................................................................................................................................................................................... 0.10 mm (0.004 inch)
If the brake disc is beyond the service limit, refinish the brake disc with an on-car brake lathe. The Kwik-Lathe produced by Kwik-way Manufacturing
Co. and the "Front Brake Disc Lathe" offered by Snap on Tools Co. are approved for this operation.
Max. refinish limit:
A/T model .......................................................................................................................................................................................... 26.0 mm (1.02 inch)
M/T model 14-piston caliper type) ................................................................................................................................................... 23.0 mm (0.91 inch)
A new brake disc should be refinished if its runout is greater than 0.10 mm (0.004 inch)
Brake disc thickness: A/T model:
Standard ....................................................................................................................................................................... 27.9 - 28.1 mm (1.10 - 1.11 inch)
Max. refinishing limit ....................................................................................................................................................................... 26.0 mm (1.02 inch)
M/T model (4-piston caliper type):
Standard ....................................................................................................................................................................... 24.9 - 25.1 mm (0.98 - 0.99 inch)
Max. refinishing limit ....................................................................................................................................................................... 23.0 mm (0.91 inch)
Brake disc parallelism ............................................................................................................................................................. 0.015 mm (0.0006 inch) max.
REAR
Brake disc/drum runout:
Service limit ..................................................................................................................................................................................... 0.10 mm (0.004 inch)
Set up the dial gauge against the brake disc/drum as shown, and measure the runout at 10 mm (3/8 inch) from the outer edge of the brake disc
Max. refinishing limit ............................................................................................................................................................................. 7.5 mm (0.30 inch)
A new disc should be refinished if its runout is greater then 0.10 mm (0.004 inch)
Brake disc/drum thickness:
Standard ....................................................................................................................................................................... 8.9 - 9.1 mm (0.350 - 0.358 inch)
Max. refinishing limit .......................................................................................................................................................................... 7.5 mm (1.30 inch)
Brake disc/drum parallelism ............................................................................................................................................... 0.015 mm (0.0006 inch) max.