TL V6-3.2L (2004)
Refrigerant Pressure Sensor / Switch: Testing and Inspection
A/C Pressure Switch Circuit Troubleshooting
NOTE:
-
Do not use this troubleshooting procedure if any of the following items are operative: condenser fan, radiator fan, A/C compressor. Refer to the
symptom troubleshooting index.
-
Before performing symptom troubleshooting, check for power train DTCs.
1. Check for body DTCs using B-CAN system diagnosis test mode A troubleshooting.
Are there any DTCs indicated?
YES - Do the appropriate troubleshooting for the DTC indicated.
NO - Go to step 2.
2. Disconnect the A/C pressure switch 4P connector.
3. Turn the ignition switch ON (II).
4. Measure the voltage between the No.1 terminal of the A/C pressure switch 4P connector and body ground.
Is there 5 V or more?
YES - Go to step 5.
NO - Repair open in the wire between the reray control module and the A/C pressure switch.
5. Turn the ignition switch OFF.
6. Check for continuity between the No.1 and No.4 terminals of the A/C pressure switch.
Is there continuity?
YES - Go to step 7.
NO - Go to step 16.
7. Reconnect the A/C pressure switch 4P connector.
8. Disconnect climate control unit connector A (20P).
9. Turn the ignition switch ON (II).
