TL V6-3.2L (2004)
^
Reinstall the inlet joint, and torque its bolt to 11 Nm (8 lb.ft).
11. Remove the feed hose bracket from the valve cover (one bolt).
12. Disconnect the P/S pressure switch connector, then remove the pressure switch from the feed hose.
NOTE:
To prevent fluid from dripping, stuff the end of a clean shop towel into the feed hose coupler.
13. Remove the 0-ring from the P/S pressure switch and install a new one, lubricated with clean P/S fluid.
14. Install the original P/S pressure switch on the new feed hose. Tighten the switch to 12 Nm (8.8 lb.ft).