acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

Computers/Controls - Updating Control Units And Modules|Page 4227 > < Computers/Controls - Updating Control Units And Modules|Page 4225
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - MIL ON/DTC P2195 or P2197 Set

04-016

July 23, 2004

Applies To: 
2004 TL - ALL

MIL Comes On With DTC P2195 or P2197 
(Supersedes 04-016, dated May 21, 2004)

Updated information is shown by asterisks and black bars.

SYMPTOM

The MIL is on, and DTC P2195 (rear air fuel ratio sensor signal stuck lean) or P2197 (front air fuel ratio sensor signal stuck lean) is set.

PROBABLE CAUSE

The ECM/PCM software incorrectly interprets sensor inputs, causing the codes to set.

*CORRECTIVE ACTION

Using the HDS, update the ECM/PCM.*

WARRANTY CLAIM INFORMATION

In warranty: 
The normal warranty applies.

Failed Part:

P/N 37820-RDA-A04

Defect Code:

07201

Symptom Code:

03203

Skill Level:

Repair Technician

Out of warranty: 
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone
Office. You must request consideration, and get a decision, before starting work.

*REPAIR PROCEDURE

NOTE:

^

Before you update an ECM/PCM, make sure the battery in the vehicle is fully charged.

^

To prevent ECM/PCM damage, do not operate anything electrical (audio system, brakes, A/C, power windows, moonroof, etc.) during the
update.

1.

Use the HDS to read and clear the DTCs.

2.

Use the HDS to update the EGM/PGM:

Computers/Controls - Updating Control Units And Modules|Page 4227 > < Computers/Controls - Updating Control Units And Modules|Page 4225