TL V6-3.2L (2004)
1. Place the new front passenger's airbag (A) into the bracket. Tighten the front passenger's airbag mounting nuts (B).
2. Connect the front passenger's airbag 4P connector (A) to the dashboard wire harness, then reinstall the glove box.
3. Reconnect the battery negative cable.
4. Connect the HDS and clear the DTCs.
5. After installing the airbag, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6
seconds and then go off.
Installation for after a collision where the front passenger's airbag deployed
1. Disconnect the battery negative cable and wait at least 3 minutes before beginning work.
2. Remove the dashboard assembly out of the vehicle.
3. Remove the dashboard upper panel from the dashboard.
4. Install the dashboard upper panel to the dashboard.
5. With the dashboard upside-down, remove the anti-contamination cover (A) from the new dashboard upper panel.
