TL V6-3.2L (2004)
^
Torque the P/S pump feed hose bolts to 11 N.m (8.1 lb-ft).
*44. Install the new feed line holder (from the kit) onto the feed and return lines located on the driver's side, and then secure it to the front suspension
subframe (one bolt).*
45. Reinstall all remaining removed parts except the right (passenger) side engine compartment cover. Replace any damaged trim clips.
46. Using the clear P/S fluid you removed from the system (or new fluid if the original fluid was contaminated or discolored), fill the P/S reservoir to
the upper level line.
NOTE:
^
Use Acura Precision Crafted Power Steering Fluid.
^
The system capacity is 1.1 L (37.2 oz).
^
The reservoir capacity is 0.32 L (10.8 oz).
47. Start the engine, run it at a fast idle, and turn the steering wheel lock-to-lock several times. This will bleed any air from the P/S system.
48. Recheck the fluid level, and add more if needed. Do not fill the reservoir above the upper level line.
NOTE:
^
Make sure you remove all shop towels used during the procedure.
^
Wipe off any spilled P/S fluid.
49. Reinstall the right (passenger) side engine compartment cover.
50. Center-punch a completion mark above the first character of the engine compartment VIN.
Disclaimer
