acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

All Technical Service Bulletins:|07-060|Page 6682 > < All Technical Service Bulletins:|07-060
Page 2
background image

Template ID:

07-060A

Skill Level:

Repair Technician

Out of warranty: 
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone
Office. You must request consideration, and get a decision, before starting work.

DIAGNOSIS

*NOTE

If you are viewing this service bulletin on ISIS and your computer has sound, click on the icon below to hear an example of the noise.*

REPAIR PROCEDURE

*NOTE
Some vehicles affected by Service Bulletin 08-016, Safety Recall: 2004-08 TL Power Steering Feed Hose Leak, were not correctly repaired in that the
power steering inlet joint 0-ring was not replaced. Before you replace the inlet joint 0-ring in this procedure, check its color:

^ If the 0-ring is not colored orange, it was not previously replaced, and this repair will correct the power steering noise at cold start-up.

^ If the 0-ring is orange, it was already replaced under S/B 08-016. Continue with normal troubleshooting to find the cause of the noise.*

1. Remove the right side engine compartment cover (7 clips and 1 bolt).

2. Remove the bolt holding the inlet joint to the power steering pump housing.

All Technical Service Bulletins:|07-060|Page 6682 > < All Technical Service Bulletins:|07-060