TL V6-3.2L (2004)
3. Place a shop towel under the pump inlet joint.
4. Twist the inlet joint back and forth until it is loose, then carefully disconnect the joint, and point the hose upward to minimize fluid loss.
5. Remove the inlet joint 0-ring.
*6. Apply power steering fluid to the new orange 0-ring, and install the 0-ring on the inlet joint.*
7. Install the inlet joint, and torque its bolt to 11 N.m (8 lb-ft).
8. Top off the power steering fluid, if needed. Start the engine, and let it idle. Make sure that the noise is gone (during a cold start-up) and that the
system is operating properly.
9. Reinstall the right side engine compartment cover.
