TL V6-3.2L (2004)
25. Install the splash shield (A).
26. Connect the Power Steering Pressure (PSP) switch connector (A).
27. Wipe off any grease from the ball joint tapered section and threads. Then reconnect the tie-rod end (A) to the knuckle arms.
28. Install the tie-rod end ball joint nut, and tighten it to the specified torque. Then install the new cotter pin (B), and bend it as shown (C) or (D).
29. Install the new cover seal (A) all the way around in the steering joint cover B. Make sure there are no wrinkles in the seal, then install the steering
joint cover B.
30. Center the steering rack within its stroke.