TL V6-3.2L (2004)
66. Hold the gearbox housing using a C-clamp (commercially available) (A) and the wooden blocks (B). Do not clamp the cylinder part of the gearbox
housing in the vise.
67. Coat the inside surface of the cylinder end (A) with power steering fluid, then install the cylinder end by screwing it into the cylinder (B). Tighten
the cylinder end to the specified torque.
68. Stake the point of the cylinder shown (opposite from where the stake was removed during disassembly).
69. Coat the new O-ring (A) with multipurpose grease, and carefully fit it on the valve housing.
70. Apply multipurpose grease to the needle bearing (B) in the gearbox housing, then install the valve body unit (C) by engaging the gears. Note the
valve body unit installation position (direction of the line connections).
71. Tighten the flange bolts (D) to the specified torque.