TL V6-3.2L (2004)
the jaw spacing by turning the adjusting bolt (B).
4. After adjusting the adjusting bolt, make sure the head (C) of the adjusting bolt is in the position shown to allow the jaw to pivot.
5. With a wrench, tighten the pressure bolt until the ball joint pin pops loose from the ball joint pin hole. If necessary, apply penetrating type
lubricant to loosen the ball joint pin.
NOTE: Do not use pneumatic or electric tools on the pressure bolt.
6. Remove the tool, then remove the nut from the end of the ball joint pin, and pull the ball joint out of the ball joint pin hole. Inspect the ball joint
boot, and replace it if damaged.
07AAF-SEPA100
1. Install the special tool onto the threads of the ball joint (A) to prevent damage to the threaded end of the ball joint pin.
2. Apply grease to the special tool on the areas shown (A). This will ease installation of the tool and prevent damage to the pressure bolt (8) threads.
3. Loosen the pressure bolt (A), and install the special tool as shown. Insert the jaws carefully, making sure not to damage the ball joint boot.
4. With a wrench, tighten the pressure bolt until the ball joint pin pops loose from the ball joint pin hole. If necessary, slightly raise the boot and
apply penetrating type lubricant to help loosen the bail joint pin.
NOTE: Do not use a hammer on the tool.
5. Remove the special tools from the knuckle and the end of the ball joint pin, and pull the ball joint out of the ball joint pin hole. Inspect the ball
joint boot, and replace it if damaged.
NOTE: If the ball joint collar/sleeve comes loose, you must replace the lower arm.
