TL V6-3.2L (2004)
2.
Locate the rear wheel sensor, and disconnect the connector.
3.
Remove the two rear wheel sensor mounting bolts. Remove the sensor.
4.
Install the new rear wheel sensor, being careful not to twist the wires. Torque the two mounting bolts to 9.8 N.m (7.2 lb-ft), and connect the sensor
to the harness.
5.
Reinstall the rear wheel. Torque the wheel nuts to 108 N.m (80 lb-ft).
6.
Clear the codes with the HDS.
7.
Test-drive the vehicle. If any ABS codes come on, do the appropriate troubleshooting in the 2004 TL Service Manual.
Disclaimer
