TL V6-3.2L (2004)
^
If you see any corrosion, mineral deposits, or water, install a new wiper linkage assembly, torque the four wiper linkage assembly bolts to
9.8 N.m (7.2 lb-ft), then go to step 21.
14.
Check the condition of the 0-ring installed between the case and the housing:
^
If the 0-ring is smooth and flat all the way around the housing, tighten the two motor screws, and go to step 15.
^
If the 0-ring is pinched and/or rolled, install a new wiper linkage assembly, torque the four wiper linkage assembly bolts to 9.8 N~m
15.
Press the snorkel from the wiper motor kit over the breather port. Make sure the flat-rounded end of the snorkel goes over the breather port.
16.
Place the pre-countermeasured or the countermeasured wiper motor in its park position by connecting the 5P connector to the wiper motor and
cycling the wiper switch one time.
17.
Install the wiper motor onto the wiper linkage using its three outside bolts. Torque the bolts to 8 N.m (6 lb-ft).
