TL V6-3.2L (2004)
18.
Move the wiper link into the park position you marked in step 7, then tighten the wiper motor center nut just enough to seat its lock washer.
19.
Move the linkage until you can fit an adjustable wrench on the wiper arm link, then hold the link with the adjustable wrench while torquing the
center nut to 31 N.m (23 lb-ft).
20.
Move the wiper link back to the park position you marked in step 7, then reinstall the wiper linkage assembly on the cowl. Tighten the four wiper
linkage assembly bolts to 9.8 N.m (7.2 lb-ft).
21.
Attach the wire harness to the wiper linkage assembly, and connect the wiper motor 5P connector. Cycle the wipers one time to get the motor and
the linkage into the park position.
22.
Lubricate the moving parts of the wiper linkage with multi-purpose grease.
23.
Only on vehicles with a pre-countermeasured wiper motor reinstalled:
Install the EPT seal from the wiper motor kit on the cowl flange:
^
Clean the cowl flange area above the wiper linkage assembly.
