TL V6-3.5L (2007)
Brake Caliper: Removal and Replacement
Front
Front Brake Pad Inspection and Replacement
Special Tools Required
Brake caliper piston compressor 07AAE-SEPA101
CAUTION
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
^
Avoid breathing dust particles.
^
Never use an air hose or brush to clean brake assemblies. Use an OSHA approved vacuum cleaner.
Replacement - Except Type S Model
1. Remove some brake fluid from the master cylinder.
2. Raise the front of the vehicle, and support it with safety stands in the proper locations.
3. Remove the front wheels.
4. Remove the brake hose mounting bolts (A).
5. Remove the flange bolt (B) while holding the caliper pin (C) with a wrench being careful not to damage the pin boot, and pivot the caliper (D) up
out of the way. Check the hose and pin boots for damage and deterioration.
6. Remove the brake pads (A) and the pad shims (B).
7. Remove the pad retainers (A).
