TL V6-3.5L (2007)
35. Lower the vehicle.
36. Align the reference mark on the steering joint and steering gearbox pinion shaft. Connect the steering joint to the steering gearbox pinion shaft.
Tighten the steering joint bolt.
37. Install the steering wheel.
38. Install the P/S pump outlet hose with a new O-ring.
39. Install the strut brace.
40. Install the under-hood fuse/relay box.
41. Install the battery base.
42, Install the air cleaner assembly.
43. Install the air intake duct, then install the breather pipe.
44. Install the battery. Clean the battery posts and cable terminals with sandpaper, then assemble them and apply grease to prevent corrosion.
45. Install the engine cover.
46. Refill the engine with engine oil.
47. Refill the power steering reservoir with the power steering fluid.
48. Bleed air from the P/S system, if necessary, add more fluid.
49. Check the wheel alignment.
50. Install the right rear engine compartment cover, then install the right side engine compartment cover.
51. Install the left rear engine compartment cover and the left side engine compartment cover.
