TL V6-3.5L (2007)
Driver/Vehicle Information Display: Component Tests and General Diagnostics
Electrical Compass Unit Input Test
Electrical Compass Unit Input Test
1. Remove the rear shelf.
2. Disconnect the 6P connector (A) from the electrical compass unit (B).
3. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose, or corroded, repair them as necessary, and recheck the system.
-
If the terminals look OK, go to step 4.
4. Reconnect the connector to the electrical compass unit, and perform the following input tests at the connectors.
-
If any test indicates a problem, find and correct the cause, them recheck the system.
-
If all input tests prove OK, the electrical compass unit must be faulty; replace it, and do the compass calibration.
