TL V6-3.5L (2007)
Driver/Vehicle Information Display: Reading and Clearing Diagnostic Trouble Codes
With Manufacturer's Scan Tool
How to Check for DTCs with the HDS
1. Make sure the ignition switch is OFF.
2. Connect the HDS to the data link connector (DLC) (A) located under the driver's side of the dashboard.
3. Turn the ignition switch ON (II).
4. Make sure the HDS communicates with the vehicle and the display panel control unit. If it doesn't, troubleshoot the DLC circuit.
5. Select Front Panel in the BODY ELECTRICAL menu.
6. Select DTCs in the Front panel menu.
7. Check for DTCs. If any DTCs are indicated, write down the DTCs, then go to the indicated DTC troubleshooting. If no DTCs are indicated, refer
to symptom troubleshooting.
NOTE:
-
After troubleshooting, clear the DTCs with the HDS.
-
For specific operations, refer to the user's manual that came with the HDS.
