TL V6-3.5L (2007)
12. Install the seat belt in the reverse order of removal, and note these items:
-
Apply liquid thread lock to the anchor bolts before reinstallation.
-
Tighten the bolts by hand first, then tighten to specification with a torque wrench.
-
Check that the retractor locking mechanism functions as described.
-
Assemble the washers, collars, and bushings on the upper and lower anchor bolts as shown.
-
If the seat belt tensioner has been activated, replace the front seat belt protector with a new one.
-
Before installing the anchor bolts, make sure there are no twists or kinks in the seat belt.
-
Before attaching the front seat belt lower anchor, make sure there are no twists or kinks in the belt. Insert the latch plate (A) into the lower
anchor (B) and be sure the lower anchor is locked securely.
-
Make sure the seat belt tensioner and tension reducer connectors are plugged in properly.
-
Reconnect the negative cable to the battery.
-
Check for any DTCs, and clear them using the HDS. If the DTCs will not clear, do the necessary troubleshooting.
-
Enter the anti-theft codes for the audio and the navigation system (if equipped), then enter the audio presets.
-
Set the clock (without navigation system).
Seat Belt Buckle
1. Make sure you have the anti-theft codes for the audio and the navigation system (if equipped), then write down the audio presets.
2. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
3. Remove the front seat.
4. Remove the center cover.
