TL V6-3.5L (2007)
19. Install the 40 mm snap ring (D) with its radiused edge facing out.
20. Coat the new pump cover seal (A) with power steering fluid, and install it into the groove in the pump cover (B).
21. Install the outer side plate (C) over the two roll pins (D) with its arrow marks stamped (E) facing down.
22. Set the pump cam ring (A) over the two roll pins with its "-" mark (B) facing down.
23. Assemble pump rotor (A) to the pump cover (B) with its "-" mark (C) facing up.
24. Set the 10 vanes (D) in the grooves in the rotor. Make sure that the round ends (E) of the vanes are in contact with the sliding surface of the cam
