TL V6-3.5L (2007)
ring.
25. Coat the new 15.2 mm O-ring (A) with power steering fluid, and install it into the groove in the side plate (B).
26. Install the side plate on the cam ring (C) by aligning the roll pin set holes (D) in the side plate with the roll pins (E).
27. Coat the new 51 mm O-ring (A) with power steering fluid, and position it in the bottom of the pump housing.
28. Install the pump cover assembly (B) in the pump housing. Tighten the bolts to the specified torque.
29. Coat the flow control valve (A) with power steering fluid, then install it and the spring (B) in the pump housing.
30. Coat the new 16.7 mm O-ring (C) with power steering fluid, and install it on the flow control valve cap (D), then install the cap on the pump
housing, and tighten it to the specified torque.
31. Coat the new 13 mm O-ring (A) with power steering fluid, and install it on the inlet joint (B). Install the inlet joint on the pump housing.
