TL V6-3.5L (2007)
2. Loosely install the new flange nuts (B) onto the top of the damper.
3. Loosely install a new flange bolt (A) on the bottom of the damper. Connect the stabilizer link (B) on the bracket (C), then loosely install a new
flange nut (D).
4. Raise the rear suspension with a floor jack to load the vehicle weight, and tighten the flange bolt to the specified torque value.
5. Tighten the flange nut while holding the joint pin (E) with a hex wrench (F).
6. Tighten the flange nuts on top of the damper to the specified torque value.
7. Install the rear shelf.
8. Clean the mating surface of the brake disc/drum and the inside of the wheel, then install the rear wheel.
9. Check the rear wheel alignment, and adjust it if necessary.
