TL V6-3.5L (2007)
^
If a clicking sound is heard, the valve is OK. Reconnect the connector, and install all removed parts.
^
If no clicking sound is heard, go to step 13.
13. Remove the nuts securing the shift cable bracket (A).
14. Remove the spring clip/washer (B) and the control pin (C), then separate the shift cable end (D) from the control lever (E).
15. Check the synthetic resin bushing (F) in the shift cable end for proper fit and wear. If the bushing is loose or worn, replace the shift cable.
16. Disconnect the connectors from A/T clutch pressure control solenoid valves A, B, solenoid harness, transmission range switch, ATF temperature
sensor, output shaft (countershaft) speed sensor, input shaft (mainshaft) speed sensor, 3rd clutch transmission fluid pressure switch, and 4th clutch
transmission fluid pressure switch.
17. Remove the bolt securing the harness cover (A).
18. Remove A/T clutch pressure control solenoid valves A and B, ATF pipes (C), gasket (D), and O-rings (E).
