TL V6-3.5L (2007)
13. Remove the spring clip/washer (B) and control pin (C), then separate the shift cable end (D) from the control lever (E).
14. Remove the shift cable bracket from the front subframe.
15. Remove the heat shield under the shift cable grommet.
16. Remove the shift cable grommet, and pull out the shift cable.
17. Insert the new shift cable through the grommet hole, and install the grommet in its hole. Do not bend the shift cable excessively.
18. Install the heat shield.
19. Install the shift cable bracket on the front subframe.
20. Apply molybdenum grease to the bore hole of the synthetic resin bushing (A) in the shift cable end (B), and attach the shift cable end to the control
lever (C), then insert the control pin (D) into the control lever hole through the shift cable end, and secure the control pin with the spring
clip/washer (E).
