TL V6-3.5L (2007)
Clutch Disc: Testing and Inspection
Clutch Replacement
Special Tools Required
^
Pressure plate compressor 07AAE-P8EA000
^
Compressor bar 07AAE-P8EA110
^
3.5 Engine clutch compressor adapters 07AAE-P8EA220
^
Clutch alignment shaft 07AAF-P8EA000
^
Pressure plate compressor adapter 07AAK-P8EA000
^
Ring gear holder 07LAB-PV00100 or 07924-PD20003
^
Attachment, 37 x 40 mm 07746-0010200
^
Driver 07749-0010000
NOTICE: You must use the special tools required to remove and install the clutch pressure plate or you will irreversibly damage it.
Pressure Plate and Clutch Disc Removal
1. Check the height of the diaphragm spring fingers using the clutch alignment shaft (A), pressure plate compressor adapter (B), and a feeler gauge
(C). If the height is more than the service limit, replace the pressure plate and clutch disc as a set.
2. Install the clutch alignment shaft (A), pressure plate compressor adapter (B), pressure plate compressor (C), 3.5 engine clutch compressor adapters
(D), bridge piece and, ring gear holder (E).
3. Turn the center screw (F) clockwise by hand to apply pressure on the diaphragm spring. Continue turning the center screw until it stops.
4. Loosen the pressure plate mounting bolts (A) in the pattern shown in several steps, then remove the bolts.
