TL V6-3.5L (2007)
4. Install the new pilot bearing (A) into the flywheel using the driver (B), attachment, 37 x 40 mm (C). Apply a light coat of oil to the bearing outer
surface.
5. Install the flywheel and mounting bolts, finger-tight.
6. Install the ring gear holder (A), then torque the flywheel mounting bolts (B) in a crisscross pattern in several steps.
Clutch Disc and Pressure Plate Installation
NOTE: The clutch disc and pressure plate are a matched set and must be replaced together.
1. Temporarily install the clutch disc onto the splines of the transmission mainshaft. Make sure the clutch disc slides freely on the mainshaft.
2. Install the ring gear holder (A).
3. Apply a light coat of super high temp urea grease (P/N 087989002) to the crankshaft pilot bushing (B).
4. Apply super high temp urea grease (P/N 08798-9002) to the splines (C) of the clutch disc (D), then install the clutch disc using the clutch
alignment shaft (E).
